3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 18:09, 28 January 2020
, 28 January 2020→Status
(→Status) |
(→Status) |
||
| Line 24: | Line 24: | ||
| :: Last known good workflow (for Chalmers) :: | | :: Last known good workflow (for Chalmers) :: | ||
1. Install slicer config | 1. Install slicer config | ||
2. Install slicer config bundle | 2. Install slicer config bundle | ||
3. set slicer to simple mode | 3. set slicer to simple mode | ||
4. increase print scale by 4.1353% (because something screws the scale up in this workflow) | 4. increase print scale by 4.1353% (because something screws the scale up in this workflow) | ||
5. slice model | 5. slice model | ||
6. load sliced model into GpxUi | 6. load sliced model into GpxUi | ||
7. translate to Replicator 2 RepRap | 7. translate to Replicator 2 RepRap | ||
|- | |- | ||
| Nov, 2018 | | Nov, 2018 | ||