250
edits
3D Printers/Creality K1: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
(→Status) |
||
| Line 9: | Line 9: | ||
</onlyinclude> | </onlyinclude> | ||
* Print monitoring page (must be on the hacklab wifi): http://192.168.133.60/#/home | * Print monitoring page (must be on the hacklab wifi): http://192.168.133.60/#/home | ||
* If trying new filaments on it, you may have to bump up nozzle temperature to get strong layer adhesion because the printer moves so fast. e.g. +10-20C over the recommended max temp. | * If trying new filaments on it, you may have to bump up nozzle temperature to get strong layer adhesion because the printer moves so fast. e.g. +10-20C over the recommended max temp. Do a small test print and try to snap it along the layers! | ||
**May not be necessary if the filament is "for rapid printing", they formulate it to soak up heat faster | **May not be necessary if the filament is "for rapid printing", they formulate it to soak up heat faster | ||
* If printing organic models and the quality is less than you want, easiest way to increase quality is to slow down print speed | * If printing organic models and the quality is less than you want, easiest way to increase quality is to slow down print speed | ||