3D Printers/Creality K1: Difference between revisions

Jump to navigation Jump to search
Line 10: Line 10:
* Print monitoring page (must be on the hacklab wifi): http://192.168.133.60/#/home
* Print monitoring page (must be on the hacklab wifi): http://192.168.133.60/#/home
* If trying new filaments on it, you may have to bump up nozzle temperature to get strong layer adhesion because the printer moves so fast. e.g. +10-20C over the recommended max temp.  
* If trying new filaments on it, you may have to bump up nozzle temperature to get strong layer adhesion because the printer moves so fast. e.g. +10-20C over the recommended max temp.  
**May not be necessary if the filament is "for rapid printing", they formulate it to soak up heat faster
* If printing organic models and the quality is less than you want, easiest way to increase quality is to slow down print speed  
* If printing organic models and the quality is less than you want, easiest way to increase quality is to slow down print speed  
** go to the monitoring page, see the panel at middle left ("Control" with the XY home buttons), set print speed there
** go to the monitoring page, see the panel at middle left ("Control" with the XY home buttons), set print speed there

Navigation menu