Makerbot: Difference between revisions
Jump to navigation
Jump to search
m (1 revision: Import 3D printer articles) |
(Add features, update status) |
||
| (7 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
[[ | [[File:Makerbot Cupcake.jpg|thumb|300px|Makerbot Cupcake]] | ||
== Status == | |||
<onlyinclude> | |||
* Hasn't been used in ages | |||
* Connected to a paste extruder</onlyinclude> | |||
== Features == | |||
* MakerBot Cupcake | |||
* Lots and lots of aftermarket 3D printed parts | |||
== Usage == | == Usage == | ||
The cupcake now runs off the same toolchain as the ultimakers, running the same Marlin firmware. This means you can treat it almost identially. (eg: Use Cura/tegh) | The cupcake now runs off the same toolchain as the ultimakers, running the same Marlin firmware. This means you can treat it almost identially. (eg: Use Cura/tegh) | ||
| Line 12: | Line 23: | ||
* [[Makerbot Manual]] -- Obsolete | * [[Makerbot Manual]] -- Obsolete | ||
* [[Makerbot Customization]] | * [[Makerbot Customization]] | ||
* [[Discov3ry Paste Extruder]] | |||
== Donations == | == Donations == | ||
[[category: Makerbot]][[category: Equipment]][[category: Projects]] | [[category: Makerbot]][[category: Equipment]][[category: Projects]] | ||
[[Category:3D Printers]] | |||
Latest revision as of 22:12, 1 February 2017
Status
- Hasn't been used in ages
- Connected to a paste extruder
Features
- MakerBot Cupcake
- Lots and lots of aftermarket 3D printed parts
Usage
The cupcake now runs off the same toolchain as the ultimakers, running the same Marlin firmware. This means you can treat it almost identially. (eg: Use Cura/tegh)
You will have to download the Cura profile from github [1] and set the dimensions in cura to match the machine. (This cannot be embedded in the profile for some reason.)
Operating ABP in tegh
The bed can be heated similar to the extruder. Note that it overshoots, raise the temperature slowly, and don't set it above 85C.
set temp b:85