3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 21:45, 9 September 2017
, 9 September 2017→Print Settings
(→Slic3r Settings: add notes to install using Ubuntu 14.04 based Linux) |
|||
| Line 56: | Line 56: | ||
These are general printer settings that work. If filament has different temperature settings, follow filament temperature settings. | These are general printer settings that work. If filament has different temperature settings, follow filament temperature settings. | ||
Smaller prints will better adhere to the bed than larger prints. If the print hasn't failed in the first 10% of the print job, it will unlikely to fail after that. | Smaller prints will better adhere to the bed than larger prints. If the print hasn't failed in the first 10% of the print job, it will be unlikely to fail after that. | ||
Use Cubic Infill (Available only in Slic3r prusa edition), as it provides rigidity in all directions [http://www.prusaprinters.org/introducing-slic3r-prusa-edition/] and doesn't make printer resonate. | Use Cubic Infill (Available only in Slic3r prusa edition), as it provides rigidity in all directions [http://www.prusaprinters.org/introducing-slic3r-prusa-edition/] and doesn't make printer resonate. | ||