251
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes
(remove ToDo List ... add Parts and Supplies Wish List) |
|||
| Line 21: | Line 21: | ||
==Known Issues and Fixes== | ==Known Issues and Fixes== | ||
* '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting to print on Ultimaker 2 | * '''IMPORTANT:''' OctoPrint will '''disconnect from Ultimaker 2''' if Ultimaker 1 is powered on. If you want to print on both (or will want to eventually), power both on before starting to print on Ultimaker 2 | ||
*LOADING FILAMENT PROBLEM: the printhead is all misaligned, specifically the PEEK peice (light brown in colour) to the teflon coupler (white in colour) above it. Trying to push filament through there to the nozzle is difficult. Try to make a long and sharp point on the end of the filament, the longer the better, so it gives plenty of space to wiggle around in when shoving it in. You can see through the tube going into the top of the teflon piece, so use that to judge how far down the filament has gone. It probably helps to have the nozzle hot, but don't keep the nozzle hot with no filament inside because it is likely to burn plastic/dust inside the nozzle and cause friction issues. | |||
* Bed is really warped (higher up in the middle, lower down on the sides). Leveling the bed is unlikely to fix this. | * Bed is really warped (higher up in the middle, lower down on the sides). Leveling the bed is unlikely to fix this. | ||
** Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). | ** Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). | ||