Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Machine Log: Print Bed & Carbon Fiber Plate notes
(→Features: update for 200mm wide carbon fiber plate) |
(→Machine Log: Print Bed & Carbon Fiber Plate notes) |
||
| Line 50: | Line 50: | ||
|- | |- | ||
|February 28, 2018 | |||
| | |||
* Using a feeler gauge & Machine Shop straight edge, determine that the center of the plate '''is high by more than 0.2mm'''. | |||
* HOWEVER, the other side has a different high/low spots pattern, that is out by '''less than 0.1mm'''. (More than 0.06mm, and less than 0.1mm) | |||
* So able to get the Carbon Fiber Plate working to print on, by ONLY using the '''one good side'''. | |||
** See the Known Issues and Fixes section, about the loose wood under-structure that holds the build plate. | |||
|Allen | |||
|- | |||
|February 20, 2018 | |||
| | |||
* 300mm X 200mm X 3mm Carbon Fiber Plate purchase for printing on is HIGH in the Center. | |||
* After installing (without cutting) takes HOURS to get the bed leveled. (Front left spring can't go up more. Back right level screw seems jammed.) | |||
* Once leveled, CAN finally print on entire print bed, but high center has print in that area toooo close, in a way that will always rip blue tape when taking the print off. | |||
|Allen | |||
|- | |||
|February 8, 2018 | |February 8, 2018 | ||