Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: update for 75mm/s FASTEST speed that can be used with PLA.
(→Recommended Filament Settings: update for 75mm/s FASTEST speed that can be used with PLA.) |
|||
| Line 32: | Line 32: | ||
==Recommended Filament Settings== | ==Recommended Filament Settings== | ||
'''CURA 3 settings for PLA by Filaments.ca''' | '''CURA 3 settings for PLA by Filaments.ca'''<br /> | ||
NOTE: 75mm/s is the fastest usable speed. If print finish/quality matters, then this might need to be reduced to 50mm/s, or even 25mm/s.<br /> | |||
'''Quality''' | '''Quality''' | ||
* Layer Height: use anything from 0.1mm to 0.3mm | * Layer Height: use anything from 0.1mm to 0.3mm | ||