Type A: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes
(→Status: update for Warped Print Bed replaced.) |
|||
| Line 26: | Line 26: | ||
* Before starting to print, '''make sure the head heatsink fan is ON'''. If the connector on the cable came loose, then the filament '''will''' jam once that heatsink becomes too hot. | * Before starting to print, '''make sure the head heatsink fan is ON'''. If the connector on the cable came loose, then the filament '''will''' jam once that heatsink becomes too hot. | ||
* This Printer has a '''removable printbed'''. So before printing, make sure that '''all 4 screwheads''' are forward to properly secure the printbed. | * This Printer has a '''removable printbed'''. So before printing, make sure that '''all 4 screwheads''' are forward to properly secure the printbed. | ||
** NOTE: the current printbed has poorly cut "key" slots for the 4 bed screws ... so it is NOT EASILY REMOVABLE. | |||
'''IMPORTANT:''' All PETG filaments are '''not''' the same. This printer can '''only''' use PETG filaments where the maximum recommended printing temperature is '''240°C'''. (MG Chemicals, iPrint-3D, Spool3D.ca & Cyclone Filament are some sources for that.) Most PETG filaments have a maximum recommended temperature of 260°C to 265°C. | '''IMPORTANT:''' All PETG filaments are '''not''' the same. This printer can '''only''' use PETG filaments where the maximum recommended printing temperature is '''240°C'''. (MG Chemicals, iPrint-3D, Spool3D.ca & Cyclone Filament are some sources for that.) Most PETG filaments have a maximum recommended temperature of 260°C to 265°C. | ||