Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Recommended Filament Settings: another typo fix (need COFFEEEEEEEEE)
m (→Recommended Filament Settings: typo fix) |
m (→Recommended Filament Settings: another typo fix (need COFFEEEEEEEEE)) |
||
Line 166: | Line 166: | ||
* As the head moves through spiderweb thin strands between printed parts, PETG filament build-up on the '''outside''' of the printhead. So any print that could be described as a "highly shaped bock of plastic" should work well, but prints where the head constantly moves over open air (no plastic under the head) are more likely to fail. | * As the head moves through spiderweb thin strands between printed parts, PETG filament build-up on the '''outside''' of the printhead. So any print that could be described as a "highly shaped bock of plastic" should work well, but prints where the head constantly moves over open air (no plastic under the head) are more likely to fail. | ||
* These settings | * These settings use a 0.35mm line width out of a 0.4mm nozzle, '''instead''' of all the other overlaps that contribute to PETG building up on the outside of the printhead. | ||
==Cura 3 Settings for this Printer== | ==Cura 3 Settings for this Printer== |