Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Known Issues and Fixes
m (→Known Issues and Fixes: wiki markup typo fix) |
|||
Line 30: | Line 30: | ||
* Retraction Speed: 30.0mm/s | * Retraction Speed: 30.0mm/s | ||
* Retraction Distance: 0.25mm | * Retraction Distance: 0.25mm | ||
* Travel Speed: 250mm/s | * Travel Speed: 250mm/s (Double what used with PLA) | ||
* Bottom Layer Speed: 20mm/s | * Bottom Layer Speed: 20mm/s | ||
* Outer Shell Speed: 20mm/s | * Outer Shell Speed: 20mm/s | ||
Line 36: | Line 36: | ||
* The above settings are a "best compromise", to get '''good''' results, without limiting the print speed any more than necessary. | * The above settings are a "best compromise", to get '''good''' results, without limiting the print speed any more than necessary. | ||
* Check the print head periodically. If PETG is building up on that, use the Black Bent Noise Tweezers to grab the PETG on the nozzle tip. | * Check the print head periodically. If PETG is building up on that, use the Black Bent Noise Tweezers to grab the PETG on the nozzle tip. | ||
* To print with PETG, start with a '''clean''' nozzle | * To print with PETG, start with a '''clean''' nozzle; and the 1st layer (inside the Brim) needs to be perfect. | ||
== Features == | == Features == |