Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Machine Log: small updates.
m (→Machine Log: small updates.) |
|||
| Line 40: | Line 40: | ||
* New PTFE lined 35mm Heatbreak & New Head used to reassemble the printhead | * New PTFE lined 35mm Heatbreak & New Head used to reassemble the printhead | ||
* ONLY an extra heatsink on the Metal Grovemount block is '''NOT''' adequate. So a fan for the AluHotend heatsink will be necessary . | * ONLY an extra heatsink on the Metal Grovemount block is '''NOT''' adequate. So a fan for the AluHotend heatsink will be necessary . | ||
* PLA will JAM due to Hotend heat creep making the AluHotend heat sink too hot. | * PLA will JAM due to Hotend heat creep making the AluHotend heat sink too hot. (Must remove Grovemount head to clear.) | ||
** PETG works, but if the fan is left off, eventually it can also stop feeding. (PETG jam | ** PETG works, but if the fan is left off, eventually it can also stop feeding. (PETG jam easily cleared w/o removing head.) | ||
* Finding exactly the correct settings to make the MG Chemicals PETG filament work well is extremely time consuming. | * Finding exactly the correct settings to make the MG Chemicals PETG filament work well is extremely time consuming. | ||
** NOTE: The listed MG Chemicals PETG temp. range is 210°C to 240°C ... which is as much as 20° less than some other PETG filaments. | ** NOTE: The listed MG Chemicals PETG temp. range is 210°C to 240°C ... which is as much as 20° less than some other PETG filaments. | ||