Type A: Difference between revisions
Jump to navigation
Jump to search
→Features: don't use over 240C
(Add Known Issues and Fixes section w/ CURA 15 PETG settings) |
(→Features: don't use over 240C) |
||
| Line 34: | Line 34: | ||
* 1.75mm filament | * 1.75mm filament | ||
* .4mm nozzle | * .4mm nozzle | ||
* Temperatures readings are lower than Ultimakers (e.g.: 190 for PLA compared to 210 on Ultimaker) | * Temperatures readings are lower than Ultimakers (e.g.: 190°C for PLA compared to 210°C on Ultimaker) | ||
* Do NOT run at more than 220°C (which should correspond to a real temp. of aprox. 240°C) | |||
* It is managed and accessible from the web GUI: '''http://octopi3.hacklab.to/''' | * It is managed and accessible from the web GUI: '''http://octopi3.hacklab.to/''' | ||
* Its manual is at http://bit.ly/1NDToMT | * Its manual is at http://bit.ly/1NDToMT | ||