Type A: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes: update PETG info for new nozzle
(→Status: Update for work-in-progress status) |
(→Known Issues and Fixes: update PETG info for new nozzle) |
||
Line 18: | Line 18: | ||
* Retraction Enabled | * Retraction Enabled | ||
** Z Hop when Retracting: 0.5mm (NO Z Hop used with PLA) | ** Z Hop when Retracting: 0.5mm (NO Z Hop used with PLA) | ||
* Print Speed: | * Print Speed: 25mm/s (Down from 60mm/s for PLA) | ||
* Pringing Temp.: | * Pringing Temp.: 235°C | ||
* Filament Diameter: whatever a micrometer reads for this reel. | * Filament Diameter: whatever a micrometer reads for this reel. | ||
* Flow: | * Flow: 65% | ||
* Nozzle Size: 0.4mm | * Nozzle Size: 0.4mm | ||
Advanced Tab: | Advanced Tab: | ||
* Retraction Distance: | * Retraction Speed: 30.0mm/s | ||
* Travel Speed: 250mm/s | * Retraction Distance: 0.3mm | ||
* Travel Speed: 250mm/s | |||
* Bottom Layer Speed: 20mm/s | |||
* Infill Speed: 30mm/s | |||
* Outer Shell Speed: 20mm/s | |||
NOTES: | |||
* The above settings are a "best compromise", to get '''good''' results, without limiting the print speed any more than necessary. | |||
* Check the print head periodically. If PETG is building up on that, touch with a Q-tip (while printing) to wick the plastic off. (Before it drops as a blob onto the print.) | |||
== Features == | == Features == |