Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Status: add filament micrometer reading
m (→Status: add filament micrometer reading) |
|||
| Line 8: | Line 8: | ||
* '''LIMITED USE''' ... can only print using PETG | * '''LIMITED USE''' ... can only print using PETG | ||
** '''Must''' use filamnet cooling fan (On once 1st layer printed.) | ** '''Must''' use filamnet cooling fan (On once 1st layer printed.) | ||
* Loaded with 1.75mm Black PETG | * Loaded with 1.75mm Black PETG (micrometer reads 1.7mm) | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||
* '''http://octopi3.hacklab.to/'''</onlyinclude> | * '''http://octopi3.hacklab.to/'''</onlyinclude> | ||