Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Machine Log: add a bit more detail.
(→Machine Log: finish update for work done last week) |
m (→Machine Log: add a bit more detail.) |
||
Line 62: | Line 62: | ||
** Heat up the head to 240°C (PETG printing Temp.) | ** Heat up the head to 240°C (PETG printing Temp.) | ||
** Tighten the Heatbreak into the Heatblock, to stop PETG leaking out of that. | ** Tighten the Heatbreak into the Heatblock, to stop PETG leaking out of that. | ||
*** Cap off block holding Groovemount ... so can rotate entire head assembly. Then a wrench on ends of Heatblock, & turn that. | |||
** Tighten the Nozzle against the end of the Tefflon Insert in the Heatbreak. | ** Tighten the Nozzle against the end of the Tefflon Insert in the Heatbreak. | ||
* Print a Filament Guide to assist filament feeding smoothly into the Extruder. ( https://www.thingiverse.com/thing:33894 ) | * Print a Filament Guide to assist filament feeding smoothly into the Extruder. ( https://www.thingiverse.com/thing:33894 ) |