Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Recommended Filament Settings
(→Known Issues and Fixes: => create Filament Settings sub-section) |
|||
Line 52: | Line 52: | ||
* All test printing was done '''without''' using the Filament Cooling Fan. | * All test printing was done '''without''' using the Filament Cooling Fan. | ||
* This filament '''really oozes''' ... so a slightly lower Temp. & a much higher Retraction was needed. | * This filament '''really oozes''' ... so a slightly lower Temp. & a much higher Retraction was needed. | ||
* Very little stringing using the above settings. | * Very little stringing using the above settings ... but POOR Layer Adhesion, and POOR Perimeter to Infill Adhesion. (Print Temp. too low???) | ||
== Features == | == Features == |