Type A: Difference between revisions
Jump to navigation
Jump to search
→Known Issues and Fixes: check heatsink fan note.
(→Known Issues and Fixes: check heatsink fan note.) |
|||
| Line 13: | Line 13: | ||
==Known Issues and Fixes== | ==Known Issues and Fixes== | ||
* Before starting to print, '''make sure the head heatsink fan is ON'''. If the connector on the cable came loose, then the filament '''will''' jam once that heatsink becomes too hot. | |||
* This Printer has a '''removable printbed'''. So sure that '''all 4 screwheads''' are forward to properly secure the printbed. | |||
'''IMPORTANT:''' All PETG filaments are '''not''' the same. This printer can '''only''' use PETG filaments where the maximum recommended printing temperature is '''240°C'''. (MG Chemicals & Spool3D.ca are 2 sources for that.) Most PETG filaments have a maximum recommended temperature of 260°C to 265°C. | '''IMPORTANT:''' All PETG filaments are '''not''' the same. This printer can '''only''' use PETG filaments where the maximum recommended printing temperature is '''240°C'''. (MG Chemicals & Spool3D.ca are 2 sources for that.) Most PETG filaments have a maximum recommended temperature of 260°C to 265°C. | ||