Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: update based on changes while using
(→Known Issues and Fixes: additional PETG filament build-up notes.) |
(→Recommended Filament Settings: update based on changes while using) |
||
| Line 26: | Line 26: | ||
* Layer Height: 0.2mm (Don't use less than this with PETG.) | * Layer Height: 0.2mm (Don't use less than this with PETG.) | ||
* Fill Density: 50% '''or''' 100% (Just what was used for testing.) | * Fill Density: 50% '''or''' 100% (Just what was used for testing.) | ||
** [... button] Infill overlap (%): 33 | |||
* Retraction Enabled | * Retraction Enabled | ||
** [... button] Z Hop when Retracting: 0.5mm (NO Z Hop used with PLA) | ** [... button] Z Hop when Retracting: 0.5mm (NO Z Hop used with PLA) | ||
| Line 35: | Line 36: | ||
Advanced Tab: | Advanced Tab: | ||
* Retraction Speed: 30.0mm/s | * Retraction Speed: 30.0mm/s | ||
* Retraction Distance: 0. | * Retraction Distance: 0.30mm | ||
* Travel Speed: 250mm/s (Double what used with PLA) | * Travel Speed: 250mm/s (Double what used with PLA) | ||
* Bottom Layer Speed: 20mm/s | * Bottom Layer Speed: 20mm/s | ||
| Line 56: | Line 57: | ||
* All test printing was done '''without''' using the Filament Cooling Fan. | * All test printing was done '''without''' using the Filament Cooling Fan. | ||
* This filament '''really oozes''' ... so a slightly lower Temp. & a much higher Retraction was needed. | * This filament '''really oozes''' ... so a slightly lower Temp. & a much higher Retraction was needed. | ||
* Very little stringing using the above settings ... but POOR Layer Adhesion, and POOR Perimeter to Infill Adhesion. | * Very little stringing using the above settings ... but POOR Layer Adhesion, and POOR Perimeter to Infill Adhesion. | ||
** Print Temp. too low??? ... need more Infill overlap??? | |||
== Features == | == Features == | ||