Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: update based on use
(→Machine Log: make & install new filament fan) |
(→Recommended Filament Settings: update based on use) |
||
Line 26: | Line 26: | ||
* Layer Height: 0.2mm (Don't use less than this with PETG.) | * Layer Height: 0.2mm (Don't use less than this with PETG.) | ||
* Fill Density: 50% '''or''' 100% (Just what was used for testing.) | * Fill Density: 50% '''or''' 100% (Just what was used for testing.) | ||
** [... button] Infill overlap (%): | ** [... button] Infill overlap (%): 50 (Very high due to low flow?) | ||
* Retraction Enabled | * Retraction Enabled | ||
** [... button] Z Hop when Retracting: 0.5mm (NO Z Hop used with PLA) | ** [... button] Z Hop when Retracting: 0.5mm (NO Z Hop used with PLA) |