Type A: Difference between revisions
Jump to navigation
Jump to search
→Status: update based on work done.
m (→Recommended Filament Settings: typo fix) |
(→Status: update based on work done.) |
||
Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
'''Printbed is warped''', with the zero stop set for a high center. The fiberglass board with a tape sheet on it helps to get the printbed a bit flatter. If needed, turn Z shaft '''clockwise''' to get flat/sticking filament. | |||
* ''' | * '''Operational''' ... use PETG head '''only''' for PETG, and the PLA head '''only''' for PLA. | ||
* The Printhead Heatsink Fan is '''always on''' ... so don't leave this printer powered on for long periods of time without printing. | * The Printhead Heatsink Fan is '''always on''' ... so don't leave this printer powered on for long periods of time without printing. | ||
* Loaded with 1.75mm | * Loaded with 1.75mm Black Filaments.ca PLA | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||
* '''http://octopi3.hacklab.to/'''</onlyinclude> | * '''http://octopi3.hacklab.to/'''</onlyinclude> |