Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: update based on usage
(→Status: update based on usage) |
(→Recommended Filament Settings: update based on usage) |
||
| Line 32: | Line 32: | ||
'''CURA 3 settings for PLA by Filaments.ca''' | '''CURA 3 settings for PLA by Filaments.ca''' | ||
'''Quality''' | |||
* Layer Height: use anything from 0.1mm to 0.3mm | |||
'''Material''' | '''Material''' | ||
* Printing Temperature: 190 °C | * Printing Temperature: 190 °C | ||
* Diameter: 1.75 mm | * Diameter: 1.75 mm | ||
* Flow: 100 % | * Flow: 100 % | ||
* Retraction Distance: 0. | * Retraction Distance: 0.65 mm | ||
* Retraction Speed: 40 mm/s | * Retraction Speed: 40 mm/s | ||
'''Speed''' | '''Speed''' | ||
* Print Speed: 75 mm/s | * Print Speed: 75 mm/s (the other print speeds are calculated from this value) | ||
* Travel Speed 150 mm/s | * Travel Speed 150 mm/s | ||
* Initial Layer Speed: 25 mm/s | * Initial Layer Speed: 25 mm/s | ||
* Enable Acceleration Control: SELECTED | |||
** Print Acceleration: 2000 mm/s (2/3 of the default value) | |||
** Travel Acceleration: 3000 mm/s (60% of the default value) | |||
* Enable Jerk Control: SELECTED | |||
** Print Jerk: 20 mm/s (the default value) | |||
** Travel Jerk: 20 mm/s (set to same as Print Jerk) | |||
'''Experimental''' | '''Experimental''' | ||
* Enable Costing: SELECTED | * Enable Costing: SELECTED (default values used for Coasting) | ||