Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: update for settings I now use with PETG
(→Recommended Filament Settings: update based on usage) |
(→Recommended Filament Settings: update for settings I now use with PETG) |
||
| Line 87: | Line 87: | ||
* Travel Speed 240 mm/s | * Travel Speed 240 mm/s | ||
* Initial Layer Speed: 20 mm/s | * Initial Layer Speed: 20 mm/s | ||
* Enable Acceleration Control: SELECTED | |||
** Print Acceleration: 2000 mm/s (2/3 of the default value) | |||
** Travel Acceleration: 3000 mm/s (60% of the default value) | |||
* Enable Jerk Control: SELECTED | |||
** Print Jerk: 20 mm/s (the default value) | |||
** Travel Jerk: 20 mm/s (set to same as Print Jerk) | |||
'''Travel''' | '''Travel''' | ||
* Z Hop When Retracted: SELECTED | * Z Hop When Retracted: SELECTED | ||