Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: Last edit to Cura 3.0.4 PETG settings (travel speed was toooo fast)
m (→Status: typo fix again) |
(→Recommended Filament Settings: Last edit to Cura 3.0.4 PETG settings (travel speed was toooo fast)) |
||
| Line 105: | Line 105: | ||
*** Inner Wall Speed: 25 mm/s | *** Inner Wall Speed: 25 mm/s | ||
** Support Speed: 25 mm/s | ** Support Speed: 25 mm/s | ||
* Travel Speed | * Travel Speed 200 mm/s | ||
* Initial Layer Speed: 20 mm/s | * Initial Layer Speed: 20 mm/s | ||
* Enable Acceleration Control: SELECTED | * Enable Acceleration Control: SELECTED | ||