Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: more notes to explain settings.
(→Recommended Filament Settings: add a few notes) |
(→Recommended Filament Settings: more notes to explain settings.) |
||
Line 95: | Line 95: | ||
* Build Plate Temperature: 0 °C | * Build Plate Temperature: 0 °C | ||
* Diameter: 1.75 mm (This should be set by the '''Material''' settings.)<br />==> if possible, use the actual measured filament dia. -- Otherwise 1.7mm seems a good "best guess" for iPrint-3D PETG. | * Diameter: 1.75 mm (This should be set by the '''Material''' settings.)<br />==> if possible, use the actual measured filament dia. -- Otherwise 1.7mm seems a good "best guess" for iPrint-3D PETG. | ||
* Flow: 94 % | * Flow: 94 % (I would '''not''' want to use anything less than this.) | ||
* Initial Layer Flow: 96 % (To get better buildplate adhesion.) | * Initial Layer Flow: 96 % (To get better buildplate adhesion.) | ||
* Retraction Distance: 0.5 mm (Retraction & Coasting work together.) | * Retraction Distance: 0.5 mm (Retraction & Coasting work together.) | ||
Line 103: | Line 103: | ||
* Retraction Extra Prime Amount: -0.0005 mm³ (That is a '''negative''' value.) | * Retraction Extra Prime Amount: -0.0005 mm³ (That is a '''negative''' value.) | ||
* Retraction Minimum Travel: 1.2 mm (3 Nozzle Width, less than 4 Line Width) | * Retraction Minimum Travel: 1.2 mm (3 Nozzle Width, less than 4 Line Width) | ||
* Maximum Retraction Count: 30 (# usually for the above Retraction Distance.) | * Maximum Retraction Count: 30 (# is usually for the above Retraction Distance.) | ||
* Limit Support Retractions: UNSELECTED | * Limit Support Retractions: UNSELECTED | ||
'''Speed''' | '''Speed''' | ||
* Print Speed: 25 mm/s | * Print Speed: 25 mm/s | ||
** Infill Speed: 25 mm/s<br />==> Can try 30 to 35 mm/s for prints with larger areas of infill.<br /> | ** Infill Speed: 25 mm/s<br />==> Can try 30 to 35 mm/s for prints with larger areas of infill.<br /> | ||
** Wall Speed 25 mm/s | ** Wall Speed 25 mm/s (Should not actually matter, since really using the Outer Wall & Inner Wall settings.) | ||
*** Outer Wall Speed: 20 mm/s | *** Outer Wall Speed: 20 mm/s | ||
*** Inner Wall Speed: 25 mm/s | *** Inner Wall Speed: 25 mm/s |