Type A: Difference between revisions
Jump to navigation
Jump to search
→Machine Log: update for work done
m (→Recommended Filament Settings: formatting edit) |
(→Machine Log: update for work done) |
||
| Line 223: | Line 223: | ||
!Notes | !Notes | ||
!Entry By | !Entry By | ||
|- | |||
|November 14, 2018 | |||
| | |||
* Had repeated/ongoing LAYER SHIFT problems with a large "lot of movements" print. | |||
** Snugged the screws to hold the plate on, as it was moving. | |||
** Tightened the printhead gantry screws. Several have nuts pulling through, so '''need to glue that part of the printer'''. | |||
** Retention both belts, by adding a printed piece onto each belt. | |||
** Still getting some Layer Shifts, so will have to try 120mm/s travel speed next. (Instead of 200mm/s) | |||
* Discovered the Print Bed Plate is no longer flat. (Small high area, centered on X-axis & bit behind Y-axis.) | |||
|Allen | |||
|- | |- | ||
| Line 236: | Line 247: | ||
|September 19, 2018 | |September 19, 2018 | ||
| | | | ||
* The PETG | * The PETG p4rinthead DIED. | ||
** broken wires due to wires flexing right at the Heater connector. | ** broken wires due to wires flexing right at the Heater connector. | ||
** Also, again getting erratic flow or PETG out of the printhead. | ** Also, again getting erratic flow or PETG out of the printhead. | ||