Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Machine Log: Update for work done by Atrain
(update for moved printer) |
(→Machine Log: Update for work done by Atrain) |
||
(One intermediate revision by the same user not shown) | |||
Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | * '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | ||
* Black PLA/PHA (This needs different retraction settings from PLA.) | * Black PLA/PHA (This needs different retraction settings from PLA.) | ||
* There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | * There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | ||
* The Carbon Fiber Plate flatness is | * The Carbon Fiber Plate flatness is "good enough" only on the side in use. | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.) | ** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.) | ||
Line 48: | Line 47: | ||
|- | |- | ||
|November 13, 2018 | |||
|Front rod that was bent replaced. (X-axis home switch needed adjustment after doing this.) | |||
|Atrain | |||
|- | |||
|May 29, 2018 | |May 29, 2018 | ||
Line 53: | Line 57: | ||
|Igor | |Igor | ||
|- | |- | ||
|February 28, 2018 | |February 28, 2018 |