Ultimaker 2: Difference between revisions

Jump to navigation Jump to search
89 bytes removed ,  18 November 2018
→‎Status: updated after work done
(update for moved printer)
(→‎Status: updated after work done)
Line 6: Line 6:
==Status==
==Status==
<onlyinclude>
<onlyinclude>
* '''Needs Work''' ... Do not use!
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size.
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size.
* Black PLA/PHA (This needs different retraction settings from PLA.)
* Black PLA/PHA (This needs different retraction settings from PLA.)
* There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly.
* There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly.
* The Carbon Fiber Plate flatness is only "good enough". (A bent rod at the front makes it seems to have a slightly high center.)
* The Carbon Fiber Plate flatness is "good enough" only on the side in use.
** Using a Brim to hold parts to the Print Bed is strongly recommended.
** Using a Brim to hold parts to the Print Bed is strongly recommended.
** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.)
** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.)
283

edits

Navigation menu