111
edits
Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
no edit summary
No edit summary |
|||
| Line 16: | Line 16: | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||
* '''http://octopi2.hacklab.to/'''</onlyinclude> | * '''http://octopi2.hacklab.to/'''</onlyinclude> | ||
==Known Issues and Fixes== | |||
*The white zip tie holding the extruder together can block the tensioner (the black piece) from contacting the filament. Make sure the tensioner clears the zip tie | |||
*Bed is warped (higher up in the middle, lower down on the sides). Levelling the bed is unlikely to fix this. Manually adjust the Z-axis for the first layer until the filament is being laid down flat (not rounded). Turn the threaded rod counter-clockwise to lower, clockwise to raise. | |||
*the nozzle is old and will need replacement soon (parts from china in the mail, supposedly). Print more slowly if the prints are not coming out good. Avoid feeding the filament over 120% feedrate, this will clog the nozzle even more. | |||
== Features == | == Features == | ||