Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
m
→Status: edit for clarity
m (→Machine Log: edit for clarity) |
m (→Status: edit for clarity) |
||
| Line 7: | Line 7: | ||
<onlyinclude> | <onlyinclude> | ||
* April 26th 2017, got great prints with the Bright Yellow PLA using these settings: 220C, speed 40 mm/s, flow 115%. | * April 26th 2017, got great prints with the Bright Yellow PLA using these settings: 220C, speed 40 mm/s, flow 115%. | ||
* Operational ... it can be Problematic | * Operational ... it can be '''Problematic''' | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled but Print Bed is NOT perfectly flat! ( | ** Bed was leveled but Print Bed is NOT perfectly flat! (Back/Right corner worst.) | ||
** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer | ** The Z axis Zero Stop is inconsistent/unreliable. It is set a bit low & user manually turns the Z-axis screw (clockwise) to bring head towards the bed just until 1st layer becomes flat. | ||
** If head too close & extruder starts clicking, that can cause filament feed problems. | ** If head too close & extruder starts clicking, that can cause filament feed problems. | ||
* Loaded with Bright Yellow 2.85mm PLA | * Loaded with Bright Yellow 2.85mm PLA | ||