Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: update status based on recent use
(→Status: update now it is finally working.) |
(→Status: update status based on recent use) |
||
| Line 10: | Line 10: | ||
** This causes print head to be too close to bed when starting next print. | ** This causes print head to be too close to bed when starting next print. | ||
** If head too close & extruder starts clicking, filament feed gear clogs with plastic. | ** If head too close & extruder starts clicking, filament feed gear clogs with plastic. | ||
* Loaded with Turquoise 3mm PLA | ** Filament has also been jamming (near the print head) mid-print. | ||
** | * Loaded with Turquoise 3mm PLA (should use 2.85mm filament) | ||
** Print nozzle is '''not''' perfectly clean ... so try 110% flow | |||
* '''PLA ONLY!''' (to prevent nozzle contamination) | * '''PLA ONLY!''' (to prevent nozzle contamination) | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||