3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 19:17, 16 April 2017
, 16 April 2017→Print Settins
| Line 78: | Line 78: | ||
For abs you '''absolutely have to''' have a heated chamber, or ABS prints not stick to kapton tape | For abs you '''absolutely have to''' have a heated chamber, or ABS prints will definitely warp and very likely will not stick to kapton tape. | ||
In order to construct heated chamber -- cover the front of printer with a piece of plywood or MDF from the workshop and put some cardboard on top of the printer out of extruder path so the heat escapes more slowly. Pre-heating heaated bed for 5 minutes before starting helps a lot -- set the Bed temperature to 100C in Octopi temperature tab. | In order to construct heated chamber -- cover the front of printer with a piece of plywood or MDF from the workshop and put some cardboard on top of the printer out of extruder path so the heat escapes more slowly. Pre-heating heaated bed for 5 minutes before starting helps a lot -- set the Bed temperature to 100C in Octopi temperature tab. | ||