Ultimaker 2: Difference between revisions
Jump to navigation
Jump to search
→Status: Update for work done.
(Updated change log: replaced head parts) |
(→Status: Update for work done.) |
||
| Line 6: | Line 6: | ||
==Status== | ==Status== | ||
<onlyinclude> | <onlyinclude> | ||
''' | * Operational ... it can be '''Problematic''' | ||
* '''Last known good settings:''' 220°, 110% flow, print 60mm/s, travel 120mm/s, 0.4 mm nozzle size, 2.85mm filament size. | |||
* OLD crap Transparent PLA. (Do '''not''' use with anything that is constantly retracting.) | |||
*'''Last known good settings | |||
* | |||
* There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | * There is a custom filament feeder on the back of the machine. Use the little red chock in the position shown here to ensure the pinch roller can grab the filament properly. | ||
* | * The Carbon Fiber Plate flatness is only "good enough". (It seems to have a slightly high center.) | ||
** Using a Brim to hold parts to the Print Bed is strongly recommended. | ** Using a Brim to hold parts to the Print Bed is strongly recommended. | ||
** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.) | ** Bed was leveled, but wood support structure is loose! (See Known Issues and Fixes section about that.) | ||
** If head too close & extruder starts clicking, that can cause filament feed problems. | ** If head too close & extruder starts clicking, that can cause filament feed problems. | ||
* Set X-axis to about 102% of Y-axis Scale to get square/round prints. ( | * Set X-axis to about 102% of Y-axis Scale to get square/round prints. (Translucent Red 20mm X/Y/Z cube by printer.) | ||
* '''PLA ONLY!''' (to prevent nozzle contamination) | * '''PLA ONLY!''' (to prevent nozzle contamination) | ||
* [[3D_Printers#Cura_15|Cura 15 Settings here]] | * [[3D_Printers#Cura_15|Cura 15 Settings here]] | ||