251
edits
3D Printers/FlashForge Creator Pro: Difference between revisions
Jump to navigation
Jump to search
3D Printers/FlashForge Creator Pro (view source)
Revision as of 01:12, 9 August 2018
, 9 August 2018→Lokbuild Print Surface
| Line 56: | Line 56: | ||
*You may see markings on the surface from where your print was. This is not a problem, you can print right on top of the markings as usual, they do not affect adherence of plastic to surface (at least for PLA... rana hasn't tried other materials) | *You may see markings on the surface from where your print was. This is not a problem, you can print right on top of the markings as usual, they do not affect adherence of plastic to surface (at least for PLA... rana hasn't tried other materials) | ||
*Praise Lokbuild god that you don't have to use tape anymore. Lokbuild will cease to adhere if ritual offerings are withheld. | *Praise Lokbuild god that you don't have to use tape anymore. Lokbuild will cease to adhere if ritual offerings are withheld. | ||
----- | |||
* | Cleaning: | ||
*use warm-hot water with dish detergent, scrub with the green side of the sponge. Rinse with water. This should remove any markings left over from prints. The surface should look good as new. | |||
*May also clean with <10% isopropyl alcohol. | *May also clean with <10% isopropyl alcohol. | ||
*DO NOT put acetone on surface or high % isopropyl, this is will damage the surface. | *DO NOT put acetone on surface or high % isopropyl, this is will damage the surface. | ||