251
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
no edit summary
No edit summary |
|||
| Line 23: | Line 23: | ||
|} | |} | ||
== Usage and Slicer == | |||
- there is no octoprint or other network connection set up yet. There is usb port on the side of the touchscreen and there should be a usb stick in it, use that | |||
- use this config file for prusaslicer | |||
[[Media:PrusaSlicer_E5P_config_bundle_physical_printer.zip]] | |||
- to load the filament push it all the way through the tubing to the direct drive extruder, then can use the knob on the extruder to load it down to the nozzle | |||
- always check the first layer!!! there is live z-adjust on the touchscreen called "baby steps" | |||
== Hardware == | == Hardware == | ||
| Line 58: | Line 69: | ||
Wait for the PEI sheet to cool before removing your prints, take it off the bed and it will cool faster. PETG can rip off the PEI coating if it too hot. | Wait for the PEI sheet to cool before removing your prints, take it off the bed and it will cool faster. PETG can rip off the PEI coating if it too hot. | ||
== SD Card == | == SD Card == | ||