251
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
→Calibration notes
| Line 65: | Line 65: | ||
* using the built in e-steps I got 137.85 steps/mm (this is in the firmware, in the slicer you just change the flow rate) | * using the built in e-steps I got 137.85 steps/mm (this is in the firmware, in the slicer you just change the flow rate) | ||
* at 220C and using PLA, got a max volumetric flow rate of 17 mm^3/s | |||
* at 250C and using PETG, got a max volumetric flow rate of 19 mm^3/s | |||
== Printable Upgrades == | == Printable Upgrades == | ||