251
edits
3D Printers/Creality K1: Difference between revisions
Jump to navigation
Jump to search
no edit summary
No edit summary |
No edit summary |
||
| Line 25: | Line 25: | ||
== Slicer - Orca slicer set up == | == Slicer - Orca slicer set up == | ||
As of writing this, the newest version was 2.0.0. To download, go here and scroll down to the "assets" section (under the "contributors" section). The windows installer .exe worked for Rana. | |||
https://github.com/SoftFever/OrcaSlicer/releases/tag/v2.0.0 | |||
Download the custom Orca Slicer profiles. | |||
Found these settings from this link, as you all should, I trust random people on the internet for everything. | Found these settings from this link, as you all should, I trust random people on the internet for everything. | ||
| Line 39: | Line 49: | ||
== | |||
== Usage == | |||
* Power switch is on lower left side corner on the back | |||
* Has a built in remote printer control over wifi, you can go to this webpage to view it if you're connected to the hacklab wifi. http://192.168.133.60/#/home | |||
=== Printing === | |||
* Before each print, a printer calibration ritual will be done. | |||
* VERY IMPORTANT: Wait until the nozzle is hot enough (can see the temperature on the screen), when it at ~150C use tweezers to remove any bit of plastic that has oozed out. This must be done because during the ritual the printer will touch the nozzle to the bed to home the Z-axis. If a bit of plastic is in between the nozzle and the bed then the z-gap will be off and the first layer will fail. | |||
* Use the glue on the smooth PEI sheet (the stock sheet that has writing on it). Don't forget to add glue to the purge line! (left most side of the bed) | |||
== Usage - Load/Unload Filament == | |||
* Turn | |||