251
edits
Line 68: | Line 68: | ||
Set up for the K1 with 0.4mm nozzle. | Set up for the K1 with 0.4mm nozzle. | ||
For printing over wifi, connect to the hacklab wifi, go to "Device" tab (select it from top middle), "+ scan add" (top right), the printer should show up. | For printing over wifi, connect to the hacklab wifi, go to "Device" tab (select it from top middle), "+ scan add" (top right), the printer should show up. When the printer is powered on, can take a few minutes for it to register on the wifi. | ||
=== Creality Print 5.0 Print Profiles === | === Creality Print 5.0 Print Profiles === |