251
edits
3D Printers/Ender 5 plus: Difference between revisions
Jump to navigation
Jump to search
→Status
(→Status) |
(→Status) |
||
| Line 8: | Line 8: | ||
**Live z-adjust is called "baby stepping", you will see it on the screen when a print job is running. | **Live z-adjust is called "baby stepping", you will see it on the screen when a print job is running. | ||
* Using the '''0.4mm layer height is recommended'''; it is hitting the max volumetric flow at this setting. Using smaller layer heights will increase time significantly (since the max flowrate is not being reached) and Rana's has not tested them. Using the 0.75mm layer height setting may perhaps save about 15-25% time for certain objects. | * Using the '''0.4mm layer height is recommended'''; it is hitting the max volumetric flow at this setting. Using smaller layer heights will increase time significantly (since the max flowrate is not being reached) and Rana's has not tested them. Using the 0.75mm layer height setting may perhaps save about 15-25% time for certain objects. | ||
* | * Octoprint (must be on lab network): greenmachine.in.hacklab.to, has webcam streaming too! | ||
* No filament runout sensor is installed. But one day it will be !! | * No filament runout sensor is installed. But one day it will be !! | ||
</onlyinclude> | </onlyinclude> | ||