3D Printers/Ender 5 plus: Difference between revisions

3D Printers/Ender 5 plus (view source)

177 bytes added , 12 September

251

edits

@@ Line 18: / Line 18: @@
 === Running a print job ===
-* there is no octoprint or other network connection set up yet. There is usb port on the side of the touchscreen and there should be a usb stick in it, use that
+* Octoprint is set up. Can also use the USB stick on the side of the touch screen, however for very large gcode files (>3MB?) there can be lag in sending gcode commands to the printer which causes stalling and gaps in the extrustion. For large gcode files use the micro-SD card that is sticking out of the power supply, or use octoprint.
 * see next section for configs for PrusaSlicer
 * always check the first layer!!! there is live z-adjust on the touchscreen called "baby steps"