Ultimaker 1: Difference between revisions
Jump to navigation
Jump to search
m
→Status
(update printer status after using for hours) |
m (→Status) |
||
| Line 6: | Line 6: | ||
<onlyinclude> | <onlyinclude> | ||
* Operational | * Operational | ||
* Loaded with | * Loaded with Black 2.85mm PLA/PHA Filament -- which is a bit more flexible than plain PLA | ||
* Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | * Works well using Blue painter’s tape '''without''' using the heated bed. (Same setup as Ultimaker 2) | ||
* '''Heated bed will cut-out mid-print''' -- so must constantly watch Octiprint to turn heat back on. | * '''Heated bed will cut-out mid-print''' -- so must constantly watch Octiprint to turn heat back on. | ||