3D Printers/FlashForge Creator Pro: Difference between revisions

3D Printers/FlashForge Creator Pro (view source)

220 bytes added , 9 August 2018

251

edits

@@ Line 53: / Line 53: @@
 *Print as you normally would. Rana finds even large prints do not curl, but use a brim or raft if you like. No fan for first layer.
 *To remove print, use the flat spatula to get underneath as usual. A room temperature print will just pop off easily. Lokbuild is durable, but if you really try you can scuff the surface.
-*You may see markings on the surface from where your print was. This is not a problem, you can print right on top of the markings as usual, they do not affect adherence of plastic to surface (at least for PLA... rana has tried other materials)
+*MUST ALLOW heated bed to cool to room temp before you remove print. Not doing so may remove the Lokbuild surface. If you're in a hurry put a fan on it.
-*Praise Lokbuild god that you don't have to use tape anymore.
+*You may see markings on the surface from where your print was. This is not a problem, you can print right on top of the markings as usual, they do not affect adherence of plastic to surface (at least for PLA... rana hasn't tried other materials)
+*Praise Lokbuild god that you don't have to use tape anymore. Lokbuild will cease to adhere if ritual offerings are withheld.
 *To clean: use warm-hot water with dish detergent, scrub with the green side of the sponge. Rinse with water. This should remove any markings left over from prints. The surface should look good as new.