Type A: Difference between revisions

NOTE: The below settings for PLA are '''very aggresive''' -- for all those who can't wait for looong prints to finish. e.g. 75mm/s is the fastest usable speed. If things like print finish and not having small holes/voids in the infill matters, then this might need to be reduced to 50mm/s. Or for printing small minatures, slowing the print speed down to something like 25mm/s might be necessary. Also, slowing the travel speed down to 120mm/s -- instead of 150mm/s -- might help. While things like retraction settings could benefit from further test prints, to try to find the "best" setting -- instead of just a setting that is "close enough to work".<br />