Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Recommended Filament Settings
(→Recommended Filament Settings: finish last update) |
|||
Line 33: | Line 33: | ||
'''CURA 3 settings for PLA by Filaments.ca'''<br /> | '''CURA 3 settings for PLA by Filaments.ca'''<br /> | ||
NOTE: The below settings for PLA are '''very aggresive''' -- for all those who can't wait for looong prints to finish. e.g. 75mm/s is the fastest usable speed. If things like print finish and not having small holes/voids in the infill matters, then this might need to be reduced to 50mm/s. Or for printing small minatures, slowing the print speed down to something like 25mm/s might be necessary. Also, slowing the travel speed down to 120mm/s -- instead of 150mm/s -- might help. While things like retraction settings could benefit from further test prints | NOTE: The below settings for PLA are '''very aggresive''' -- for all those who can't wait for looong prints to finish. e.g. 75mm/s is the fastest usable speed. If things like print finish and not having small holes/voids in the infill matters, then this might need to be reduced to 50mm/s. Or for printing small minatures, slowing the print speed down to something like 25mm/s might be necessary. Also, slowing the travel speed down to 120mm/s -- instead of 150mm/s -- might help. While things like retraction settings could benefit from further test prints -- to try to find the "best" setting, instead of just a setting that is "close enough to work".<br /> | ||
'''Quality''' | '''Quality''' | ||
* Layer Height: use anything from 0.1mm to 0.3mm | * Layer Height: use anything from 0.1mm to 0.3mm |