Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: add travel speed note
(→Recommended Filament Settings: add travel speed note) |
|||
| Line 113: | Line 113: | ||
** Top/Bottom Speed: 20 mm/s | ** Top/Bottom Speed: 20 mm/s | ||
** Support Speed: 25 mm/s | ** Support Speed: 25 mm/s | ||
* Travel Speed 200 mm/s | * Travel Speed 200 mm/s (The '''maximum travel speed''' for this printer.)<br />==> Using travel speeds above 200mm/s was contributing to occational X/Y axis layer shifts -- which took months to resolve. | ||
* Initial Layer Speed: 20 mm/s | * Initial Layer Speed: 20 mm/s | ||
* Enable Acceleration Control: SELECTED | * Enable Acceleration Control: SELECTED | ||