Type A: Difference between revisions
Jump to navigation
Jump to search
m
→Recommended Filament Settings: formatting edit
m (→Recommended Filament Settings: formatting edit) |
m (→Recommended Filament Settings: formatting edit) |
||
| Line 150: | Line 150: | ||
'''Experimental''' | '''Experimental''' | ||
* Maximum Resolution: 0.01 mm | * Maximum Resolution: 0.01 mm | ||
* Enable Costing: SELECTED | * Enable Costing: SELECTED<br />==> Costing together with a small retraction seems to works better than using just retractions.<br /> | ||
* Costing Volume: 0.1 mm<sup>3</sup> (aprox. 150% the Cura 3 default value) | |||
* Minimum Volume Before Coasting: 0.8 mm<sup>3</sup> | |||
* Coasting Speed: 100 % | |||
* Alternate Skin Rotation: SELECTED (UNSELECT this when using Supports.) | * Alternate Skin Rotation: SELECTED (UNSELECT this when using Supports.) | ||
* Use Adaptive Layers: SELECTED | * Use Adaptive Layers: SELECTED | ||
* Adaptive Layers Maximum Variation: 0.05 mm | |||
* Adaptive Layers Variation Step Size: 0.01 mm | |||
* Adaptive Layers Threshold: 180 (Default value is 200)<br />==> 180 seems to provide about same quality & speed as using a 0.1mm layer height with PLA on Ultimaker 1. | |||
<br /> | <br /> | ||
NOTES: | NOTES: | ||