Type A: Difference between revisions
Jump to navigation
Jump to search
→Machine Log: finish update for last work done.
(→Machine Log: firmware update to get new head running.) |
(→Machine Log: finish update for last work done.) |
||
| Line 65: | Line 65: | ||
** Had to completely unplug this printer (including USB) for a couple of min. to get auto-tuning to stop continuously running. | ** Had to completely unplug this printer (including USB) for a couple of min. to get auto-tuning to stop continuously running. | ||
** Set the "good" values that were written down into Octoprint. (Will flash those values into firmware next.) | ** Set the "good" values that were written down into Octoprint. (Will flash those values into firmware next.) | ||
* Was '''not''' able to get the PETG to stop leaking out between the Heatbreak & the Heater Block. (Not willing to risk breaking another Heatbreak.) | |||
** Finally resorted to using some ABS filament where the Heatbreak comes out of the Block to seal that. | |||
|Allen | |Allen | ||
|- | |- | ||