Type A: Difference between revisions
Jump to navigation
Jump to search
→Recommended Filament Settings: + infill overlap note + support pattern
(Filament Settings up one level & add iPrint3D PETG) |
(→Recommended Filament Settings: + infill overlap note + support pattern) |
||
| Line 28: | Line 28: | ||
* Infill Pattern: Zig Zag | * Infill Pattern: Zig Zag | ||
* Infill Overlap Percentage: 50 | * Infill Overlap Percentage: 50 | ||
* Skin Overlap Percentage: 10 | * Skin Overlap Percentage: 10 | ||
The Infill Overlap is '''extremely high'''! This value is used to ensure the infill will not separate from the Sell layers.<br /> | |||
'''Material''' | '''Material''' | ||
* Printing Temperature: 240 °C | * Printing Temperature: 240 °C | ||
| Line 46: | Line 47: | ||
* Z Hop When Retracted: SELECTED | * Z Hop When Retracted: SELECTED | ||
* Z Hop Height: 0.5 mm | * Z Hop Height: 0.5 mm | ||
'''Support''' | |||
* Support Pattern: Lines | |||
'''Cooling''' | '''Cooling''' | ||
* Enable Print Cooling: UNSELECTED | * Enable Print Cooling: UNSELECTED | ||
'''Special Modes''' | '''Special Modes''' | ||
* Print Sequence: One at a Time | * Print Sequence: One at a Time | ||