Type A: Difference between revisions
Jump to navigation
Jump to search
clarify Cura 3 setting title
(clarify Cura 3 setting title) |
|||
| Line 84: | Line 84: | ||
* As the head moves through spiderweb thin strands between printed parts, PETG filament build-up on the '''outside''' of the printhead. Despite this, any print that could be described as a "highly shaped bock of plastic" will work well. But for prints where the head constantly moves over open air (no plastic under the head), the melted PETG dropping off the outside of the printhead might cause that print to fail. | * As the head moves through spiderweb thin strands between printed parts, PETG filament build-up on the '''outside''' of the printhead. Despite this, any print that could be described as a "highly shaped bock of plastic" will work well. But for prints where the head constantly moves over open air (no plastic under the head), the melted PETG dropping off the outside of the printhead might cause that print to fail. | ||
== Cura 3 Settings == | ==Cura 3 Settings for this Printer== | ||
To use the below settings, create a '''Custom FDM printer''', then edit the '''Machine Settings''' for that printer to contain the following:<br /> | To use the below settings, create a '''Custom FDM printer''', then edit the '''Machine Settings''' for that printer to contain the following:<br /> | ||
'''Printer Settings''' | '''Printer Settings''' | ||