Search results
Jump to navigation
Jump to search
- *1.5HP, 100 to 5140 RPM (two speeds, belt adjust) ...ion tool. All members are welcome to use the machine after being shown how to use it properly. ...7 KB (1,060 words) - 16:17, 6 March 2023
- '''If you do not know how to use this tool, do not attempt to use it.''' * If you have to leave the lathe unattended, or you are done using it. ...8 KB (1,388 words) - 18:04, 29 March 2022
- Type A lives on the third shelf of the 3D printer tower, next to [[Ultimaker 2]] * '''http://octopi3.hacklab.to/'''</onlyinclude> ...29 KB (4,680 words) - 02:42, 1 July 2020
- ...edly. Given the quality and constraints of this printer, there is no value to it beyond as a parts machine. - ATrain ...has been a poor state of repair. Filament is jamming when members attempt to use it. ...15 KB (2,567 words) - 23:30, 26 February 2024
- ...controlled by a Linux package called [http://www.linuxcnc.org/ LinuxCNC]. To drive the laser, LinuxCNC plays [http://en.wikipedia.org/wiki/G-code G-code ...at can be used to measure this. From the base of the large end of the post to the top of the tapered part is 2 inches. ...40 KB (6,823 words) - 19:08, 3 November 2018
- ...out, mostly because we're total geeks, but partly so that if we ever want to repeat something, we can know what we did :-). Most dinners are eaten from This is Eric's rough run sheet for an open house dinner, to help other people run them: ...162 KB (24,867 words) - 17:07, 20 June 2023